Quote Originally Posted by Jon Wehrenberg View Post
Converters all use the engine area differently. Virtually all the space accessible through the rear doors is occupied or required to access something, like the electrical box.

That leaves the RH side door above the batteries. Unfortunately that space is occupied in various ways also. Some coaches have house batteries above the chassis batteries and some have boxes designed to hold sewer hoses or other stuff like emergency reflectors.

I don't think AFO can approach every Prevost as a custom installation. They would go nuts trying to fabricate brackets and supports and other mounting devices depending on the type shell, the age of the shell or the converter.

So if the engine area is out, the next logical place is on the forward bulkhead in front of the drive axle. Unfortunately Prevost has used that space to mount the system for the hydraulic stabilizators on some coaches, and some converters like CC have used that open space to hold a condensing coil for their AC system making access to the bulkhead out of the question.

Behind the front bumper? Nope, some fill it with Cruise Airs, others have a drawer there, and some use it for things like the aux air compressor.

Steer compartment? Nope, some owner have hose reels or aux air compressors there.

In a bay? Nope, no two converters use bay space the same so there wouldn't be anything standard there.

That leaves between the tag and drive axles, and even that is going to be tough standardizing because of the accumulator tanks.
I have sealed off the brake air leak, removed all valves, cut, crimped, sealed, taped, wire tied, glued and wire crimped all lines, tested the bus brake air, 130lbs blew off nicely and seems to be holding well.

I placed 2X12's boards under the Tag axle jack points, placed 2 20 ton jacks at each point plus 2 12 ton can't have too many and went to town.

I must say that even with the bus aired up higher in the back and the jacks underneath with some extra jacking it is still somewhat of a tight space to crawl into, but once there and sitting on your butt looking up there is enough room.

I am still not overly exited about being in and getting to and from this space.

I did not take any pictures because there was not much to offer, as all major parts are either dangling on the ground or simply gone, sorry.

I simply cut away both valves and all three lines, capped them off carefully especially the main line from the Bus air brake. I crimped each line about 8"s, used a mental locking ring, 3 on each line, tape, a new type of super glue in the open end, then heavy duty tape along the entire crimped section, I think it is very tight now. I finally wire tied the finished product up to and along the run of hoses that were wire tied above the air lines, I think it is good to go for a long trip if needed, and with IKE heading at us CAT4 I just might close the shutters, grab some steaks and head on down the road.