Quote Originally Posted by Jon Wehrenberg View Post
I am guessing by your description that valve is not closing. It sounds like it is bad. As stated before Prevost sells the kit to replace the valve. it consists of the valve body and all that is necessary is to remove the defective one and replace it. Two screws and a "C" ring and that's all that is required to be removed and the valve body comes off the manifold.

The new valve will have a new "O" ring to go under it, replace the two screws, put on the coil and the "C" ring and your problem should be solved.

If the converter did not modify the system that should be the valve that controls the left rear. If the leak is not too bad you can drive the coach, but be aware you will be working your compressor to keep up with the leak.
I have successfully repaired the solenoid thanks to all of you. This only proves that it is possible to walk the mechanically challenged through problems successfully.

Here is how I handled it: I first took off the clip, removed the first half then removed the flat and torc screws. The large "O" ring had some kind of crap on it that clearly would open the seal. I took the entire solenoid apart, cleaned each "O" ring including the area where it rests, removed the spring inspected it, cleaned its ends and replaced all parts, pressurized the system and all is good.

PS: all O rings looked as good as new, but the end of the spring near the magnet was very dirty and needed cleaning.

Thanks again.