-
Solar load dumping #1
In my research on the electronic dash replacement.
I stumbled across a YouTube video on a narrow boat where they take excess solar power after the batteries are fully charged and dump the energy into the hot water heater.
They were using a manually controlled variac to soak up the excess solar power and were basically setting a value of 500 watts.
You know those kind of idea's that percolate in your brain and wake up at 1AM?
This is one of them!!!
In my DIY hydronic system I make use a couple RV hot water heaters as my heat storage.
When I am on shore power they cycle between 180 and 120 degrees due to the large hysteria between the high and low points on the temperature switch.
The hotter the hydronic storage temperature the shorter the time period that the toe kick heaters need to be running to heat the bus.
So my idea is going to be to kill two birds with one stone by monitoring the tank temperature (which I am already doing for logging) and turn off the power input just before it reaches maximum temperature so that the temperature switch never triggers.
Plus I can also use it as solar power dump controller to maximize my solar power usage and more and likely have more hot water availability when off grid.
If the automation fails in the off mode, no big deal. If it fails on; then the normal built in switch takes over.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules