Hi Hector,

Thanks so much for your response. After reading your post, I rechecked each switch just to be sure they were in the correct position. Looking at them, they looked correct but I noticed on the level low 4 position switch may be on "front" rather than drive. I cranked up the coach and spun the switch around. I also flipped the auto level back to the level mode momentarily and then back to off. The "Level Control" indicator light went out and after a few minutes the coach pumped up to ride height. Clearly the first (but I doubt the last) case of operator error.

Again, thanks for taking the time to respond.

Best Regards

Bob