Ok you can blame this on automation or design choices by yours truly. Given that I have made a living from software relate stuff for 40 plus years, I do tend to try and be a little smarter or dumber until I work all the bugs out.

Anyway my bus house systems automation has been based on very local (inside my bus, not dependent on reaching the Internet) Internet of things (IOT) stuff. The brain of my house automation is Raspberry Pi on a bus wired/WiFy network that is private to the bus.

As part of the design I went with Shelly Humidity and Temperature sensors that are battery powered. They are suppose to wake up every five minutes and detect the current values and if they have changed by X amount connect to the local WiFy network and report the change.



As you can see I have one such sensor stuck up on the wall of my bathroom.

As a sensor the drawback is that they are battery powered and I am on my second set of batteries in the last four months.

As a side note I am not yet living in the bus so it's going through larger temperature extremes then if I lived in it, so probably more reports than what would be normal.

Given that I plan on living in the bus full time for the next 10-15 years, maybe I should get them directly wired so they can be more reliable.



As you can see from the above graphic there was no kitchen reports until I inserted my last spare battery this evening...

While I could make the automation software ignore a heat zone or use the nearest zone if a zone is not reporting, I thing a hardware solution is more appropriate. I.E. Add some wires to provided power so that they are always ON!!!!