Things are starting to cascade towards getting finished with the first phase!!!
Anyway the next item on my wish list was a better shower.
This was quite the install process as it didn't fit where the old shower head was. The layout of my bus in this area is:
The refrigerator/freezer has been sitting in the aisle for sometime because I have been running my solar panel and network wiring on the rear wall. This space is a vertical column of the house battery bay, refrigerator/freezer and roof vent. The refrigerator/freezer is being converted from propane/electric to a simple DC compressor setup to eliminate propane in the bus and use 1/6 the electrical power.
Anyway I had to cut through the wall of the cabinet that holds the refrigerator/freezer to get through the pocket door and then to the back of the shower to mount the new shower head.
This is very tight space, so visited a number of hardware stores until I found some 72 inch stainless steel hoses so I wouldn't have a connection that I couldn't reach.
Also because of the sliding pocket door I had to be careful in routing these hoses so they wouldn't interfere with the pocket door.
![]()





Reply With Quote