-
I hear you the oil can be messy if the use is not targeted. What i do is put a little cutting fluid in a small shallow dish, something heavy so it won't flip over move around easily. Only let the fluid get about 1/16" deep. When you are ready to drill, just touch the end of the drill in the fluid, it doesn't take much and this is the only place you want the fluid (on the drill point), if you feel the drill is drying out, just touch the drill in the fluid again. If you do this, most of the fluid will dry up in the drilling operation which is what you want. Shop vac and a paper towel should be all you need to clean up.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules