With the new surge tank doing the degassing functionality I was able to simplify the hydronic output manifold as it no longer needed an air vent in the mixture.
Here's the old rube Goldberg setup:
And here's the new much simpler layout:
A quick note about this type of electric ball valve. It only draws power when it is changing position, one voltage polarity drives it open and the reverse drives it closed:
Very important to test it and record which polarity goes to which colored wires before you hookup all the plumbing and can no longer see it!!!
So in my case I use a DPDT relay so that when it is not energized the default voltage polarity drives it to the open position.
Here's the last picture that I have on hand which show's the temperature probe installed into a tee.
This sensor is out of view in the picture, but I will now have readings on the feed and exit temperatures for the diesel boiler loop.






Reply With Quote