Turns out going from a half an inch to 3/4 inch is a bit of chore:
You first have to convert the 1/2 into 5/8 inch and then 3/4 inch!!! Oh yeah, it also has a sensor hole that needs plugged and takes a 14mm bolt in 1.25mm pitch to plug it.
So anyway I just threw it into the engine compartment before I fabricated a mount for it to test it out.
I had partially drained the system before hooking in this tank. I made no special effort to purge air out of the system, simply filled it up and turned the zone and stir pumps on for about twenty minutes.
And hey it automatically started purging air from the system; as it did that you would see the level drop in the surge tank!!! Which I had to top off a few times before the level stabilized.
Time for another test run!!! Pulled out my cell phone and commanded via the bus's web page to start the diesel boiler and hey it fired right up!!!
Simply magic (grin)....
This time there was no hesitation or early shutdowns and the system reached 145 degrees before the boiler started idling.
Since this boiler was part of a military kit for generators in the arctic it may have be programmed for lower set points. I have the diagnostic software and USB interface; will have to figure out how to hook it up and investigate the settings.
But hey a major step forward, time to finish it up!!!




Reply With Quote