Does anyone have any experience replacing or fixing the engine radiator? I seem to have a small leak in a corner seam that is spraying coolant. Looking for any advice on cost, who can replace, how hard the radiator is to remove, etc.
Does anyone have any experience replacing or fixing the engine radiator? I seem to have a small leak in a corner seam that is spraying coolant. Looking for any advice on cost, who can replace, how hard the radiator is to remove, etc.
There's a gasket between the core and the end caps. You might get lucky and try tightening the bolts holding the end caps on.
A new radiator is in the $5K range. If you have time and the end caps are good, you may want to consider a recore. If it's a road hazard puncture and the radiator is otherwise good, the puncture can be sealed.
Gil and Durlene
2003 H-3 Hoffman Conversion
Gil,
Thank you for the information. I was just looking at the parts diagram and see the end caps and gasket. The area it is leaking is the end cap. I will try tightening the bolts and see if it helps. Do you know if the gasket can be replaced without removing the radiator?
I doubt the end caps can be removed without removing the radiator.
Gil and Durlene
2003 H-3 Hoffman Conversion
20201020_110701.jpg
20201020_110723.jpg
2000 chassis
20201020_111336.jpg
20201020_113211.jpg
20201020_113224.jpg
20201020_113158.jpg
Its a piece of the radiator, bottom bracket, that can be had from the manufacturer 260 bucks. This is one of those deals where everything on and around this chassis is rust free and this 1 piece is all corroded to hell.
20201020_154646.jpg
Last edited by Joe Camper; 10-20-2020 at 04:49 PM.
1990 Peterbuilt 377
3406 B Caterpillar
13 Speed Roadranger
No Norgrens
1 day on paper no machines
How hard was the job and was it difficult to find a fab shop that would do a quick turn around?
Gil and Durlene
2003 H-3 Hoffman Conversion