Replacing Halogen bulbs with LED's

[Biodieselpete]

My Vantare has Halogen bulb lighting by OSRAM #64415, 12V 10 watts and I want to replace these with LED bulbs.

Can I just replace the bulb without special modification? AND, where do I find the LED Bulbs?

Thanks!

[ajducote]

Check out this thread. It has some information and links to some led suppliers.

http://forum.prevostownersgroup.com/...ght=led+lights

Oh, and welcome to the group.

[BenC]

LED lighting fixtures in general , like fluorescent fixtures, cannot be dimmed via reducing the voltage to the light like halogen and other incandescent bulbs are dimmed. The dimming scenario for LED's has been the biggest holdup in their wide-spread usage in high-end coaches. Special circuitry is required to dim them that reduces the current flow, NOT voltage to the light.

Vantare coaches utilize a dimmer resistor network to dim the salon ceiling, galley ceiling, bath ceiling, and bedroom ceiling lighting. Sequential pushes of the switch add more resistors in line with the bulbs to get the dimming effect you have. The LED lights would/will work fine on the full bright setting (bypassing both resistors), but the 2nd and 3rd stage will cause premature failure to the LED fixture if left in that condition for long and will not work correctly, if at all. Think of it this way, LED assemblies are electronic appliances that produce light, they are not simply lighting fixtures like a halogen bulb. Electronics do not like/function properly with low voltage or high voltage conditions. Hope this helps.

[Ray Davis]

So, I assume that Marathon coaches with their progressive dimming would have the same issue?

[BenC]

Unfortunately, you are correct. Pulse-width modulation or resistive dimming both have the same net result, which is low voltage to the light fixture.

[Ray Davis]

Thanks Ben, I had been contemplating changing to LED bulbs, but didn't realize they had this limitation. I don't often dim them, however I wouldn't want to burn things out accidently either. Those LED fixtures are still pretty pricey. I was more concerned with lower power and less heat ...

[Roadpilot]

I have a Millennium that has dimmable LED lights in place of Halogens. They work great and throw off no heat. An LED light is a light emitting diode that is forward biased. It would br preferable to dim it by reducing the current through it since it's forward voltage curve is relatively steep (not as steep as a silicon diode though). I know for a fact that if you reduce the current through an LED you will not kill it, you will increase it's life and it will dim. You could keep the current constant and modify the time it was on. And to the eye it would look dimmer.