Quote Originally Posted by garyde View Post
The sequence for opening is as follows: When you push the button to open:
1. The air seal begins to deflate
2.once deflated, the pins retract from the slide
3. the slide motor begins to move the slide out
4 once out, the slide seal inflates

This sequence is reversed when closing

So, if your error light begins at the beginning of this process , it is an air issue, possibly not enough air pressure in the system to begin the sequence.
If you get an error light later in the sequence, it might indicate too much current draw on the motor which indicates the motor is working too hard.
I think it is the latter...the motor is working too hard for some reason. The light does not blink until the very end of travel outward. The error I get is that there is over current while in operation. I am suspecting something is not adjusted right and at the end, it gets too hard to finish without really working the motor.

On closing I do not get the error and the motor does not sound like it is working as hard.

I guess I will have to get it looked at. I also have a very annoying squeak coming from that front slide. It is like fingers on a chalk board....