If there is enough interest I will design a few pieces (my brain hasn't gotten that far yet) and see if I can get a price on the parts. I doubt if we are talking about more than $10 or $15. Right now I am thinking about some angles at the top secured to the top of the box and the bulkhead and a strip on each side to secure the box to the brackets. It will involve some drilling and the use of sheet metal screws, but it will be a permanent repair.

This will be a one shot deal so I will need a head count. While we are tallying up the numbers I will start trying to figure out a design for the parts.

In the interest of full disclosure I will buy these parts from Jamestown Advanced Products which is owned by my daughter and I will sell them at my cost. This is not a profit making endeavor.