ABS Brake Dash Light

[0533]

I am getting an ABS idiot light on my dash. It is supposed to go out after you reach 4 MPH but it does not. I think it is a connection as it is not happening every time I drive off. Any ideas where I should look for a sensor or connection ??

[Jon Wehrenberg]

Bruce,

I haven't done this but I think there is a way for you to flash the ABS codes. I scanned my ABS system book once and saw there is a way to read the code.

FWIW mine will stay on if it has been damp or raining just before I drive. The next time I turn the bus off after driving a while and then restart the bus it will go out. I have never bothered to check why it is doing that because when I get to a place where I can mess with it, it is usually not lit.

[0533]

I have experienced this as well. I read my codes, nothing ABS related. Is there a sensor or fuse? Wires leads etc???

[Kevin Erion]

Bruce,
On that year they had problems with the sensors in the rear end. They have to remove the ring and pinion to replace the sensors. It gets little costly to fix!

[0533]

What is a ring and Pinion, remember you are speaking to a regular citizen here. I am heading to Prevost for my Tag tire upgrade and a few odds and ends should I have them look at this or live with it??

[merle&louise]

Bruce,

I have experienced the same problem with the ABS light coming on & off when it is raining or high humidity. It always goes off after the weather clears up and dries out.

[Jon Wehrenberg]

Bruce,

You will not read ABS codes where you read DDEC codes. If you go to the ABS owner's manual it will tell you how to read the codes. I have a switch next to my computer receptacle for my ABS.