CQ Hams

[jello_jeep]

Any ham radio types out there? Have you found any acceptable way of mounting antennas on you bus? What did you use? How did you access it??
Inquiring minds want to know!

[Ray Davis]

I've never had a rig in my buses. Had two meter gear in GMC which I removed the CB whip and replaced with 2 mtr whip. Worked fine. But, that was mounted on the side mirror, which wouldn't look too cool on those Ramco's.

I wouldn't mind putting in a 2/220/440 in someday, but assume I'll need to put a hole through the roof to accomplish it.

Ray

[ronwalker]

It was easy to replace the factory-installed FM antenna on my H3 with a quarter wave 2M/440 whip. I just used the same hole in the roof. 'Makes a great tree feeler. I will install a linear actuator powered rotating bar mount later and bring the cables down through a hidden pipe.

KF4VVL

[jello_jeep]

I was fixin to mount up one of my old 742A's in there. Currently 2/440/1.2 but I am fixin to swap out the 1.2 mod for a 220 mod I think.

Ron, where do you get a motorized antenna bar? I haven't seen that on..

What part of AZ you hang out in??


KN6IG

[ronwalker]

Motorized antenna raising and lowering is often done using linear actuators like those offered at http://www.satellitedish.com/cata0057.htm. I chose the 18" ones to rotate two bar mounts. Some other variations are covered at http://www.kc8qvo.com/. I have the components, but the design is still in my head. 'Too many higher priorities for now.

'Been snowbirding between Flagstaff and Yuma.

[Sid Tuls]

Like to get some information on CB radio antena's. I don't have one on my bus and like to install one. Went to the truck stop and feel they can do it but don't feel real comfortable with them drilling a hole if they haven't done it before. So I guess I'am asking if anybody happens to have a picture on their bus showing the place of were thiers is mounted I would like to see a picture if possible. Thanks