134A sight glasses

[jack14r]

My 05 coach has 134a OTR air with 2 sight glasses in the evaporator bay,should both red balls in the sight glasses be floating,should both the glasses be clear?I have 16 degrees of temperature differential at fast idle,how much should a 134a system have?

[Jon Wehrenberg]

Jack,

The sight glasses in my coach look impressive but are of no assistance. Sometimes the ball is sitting on the bottom, and other times depending on whether it is cycling the ball is right up to the top.

FWIW at about 85 degrees I had suction of about 43 psi and about 150 on the high side.

My discharge air temp at the vent next to the passenger seat was about 65, and on the driver's air about three degrees higher. I may have a mixing valve on the driver's air leaking a little coolant to explain the slightly higher temp.

[jack14r]

Thanks Jon,The balls seem to have a mind of their own.Today it was 80 degrees here and I had 35 and 150 on the gauges with 55 degrees at the output on the OTR air,I did not check the dash temperature.Based on the chart that Prevost has on their web site I should have 45 and 158 today according to the numbers I entered into their chart.I wish the sight gauges would tell me something.what are they for?

[Jon Wehrenberg]

I have no clue what those sight gauges are for unless we both are overcharged.

They do not run in the middle on mine, being either empty or full.

I would say the pressures and temps are fine. I know I can hang meat in mine. Our AC was running about ten minutes or so when the temps were checked so maybe we could get lower, but from driving I can tell you I have to run my temp setting up about 25% of the rotation up off the coldest setting and even there it may get too cool. I think you have a digital set point on yours.

[wrongagain]

here are a couple of web sites I have directed some of my former employees to hoping a picture would be worth a thousand words.

http://www.refrigerationbasics.com/1.../charging1.htm

http://hvac-talk.com/vbb/

[Joe Cannarozzi]

Ed Thank you for that post. Access to a site like that second one should be volumes of help for a novice like me.