1995 Liberty EL 40: Setting the rack (rails)

[Jim_Scoggins]

Joe, Toy Box
Runs good, starts quick, no smoke.
Jon, all:
Being intuitively lazy, I will gladly buy you all six rounds of your favorite spirit in appreciation of all the work you saved me!

Will even include dalej, who, by claiming lack of knowledge, cut and ran.

[Jon Wehrenberg]

Stick with us Jim. We are refining our method of providing answers. If I did not know the answer I just made something up. Now if I don't know the answer I still make something up, but I make up an answer you want to hear.

[Jim_Scoggins]

Just for information. Here is some info from some kind folks from the other forum:
-------------------------------------------------------------------------
Coloradobus
Member
Member # 153

Member Rated:
posted September 06, 2007 11:51
--------------------------------------------------------------------------------
Jim,

On our first bus, a 1999 shell called 2001 Country Coach with 2 HWH slides, we pulled the dresser drawers out and saw some screws that held an insert that the drawers slid into. Once removing that insert, we were able to access the floor panal underneath the insert to get at the valve cover.You may have to pull come carpet as well. We did have to take the mattress off the bed for more elbow room. You may have it easier not having a slide..

[ September 06, 2007, 11:53 AM: Message edited by: Coloradobus ]
--------------------------------------------------------------------------------
Posts: 443 | From: Intermountain West | IP: Logged |

steamguy56
Junior Member
Member # 1880

Rate Member posted September 08, 2007 13:11
--------------------------------------------------------------------------------
Jim
was in this area this a.m. the hatch is 40" from the left, 37" from the right. Revealing the 21" wide x 30" long hatch. When it was opened 3/4 of valve cover in plan view. This is on my 1997 Le Mirage 45.... I just desided to build the bed length wise. hope this helps Danny.
--------------------------------------------------------------------------------

[Joe Cannarozzi]

Jim

We have a rear kitchen and bath.

How is this for easy access. Takes about 10 min. This is what it is configured like if you should ever have to get to it.

My Bus 336.jpg
The kitchen sink is the back of the bus.

My Bus 337.jpg
The hatch is L-shaped it goes up the back about 6 inches. 3 screws on the floor 3 more on the back.

My Bus 338.jpg
The wall between the kitchen and bath was tongue and grooved for hatch removal.