20170909_143014.jpg
20170909_160038.jpg
20170909_161513.jpg
Here we go again. A forklift is the preferable tool for this job but if you're very careful you can get away with a tractor as small as this this thing was just barely big enough to pick up one end and then the other. I just took my time and went back and forth and blocked it up till it was high enough and I got her into the back of my 1ton van.
This was a great thread to revisit for this project. This gen has 20 some thousand hrs on it. Still made good reliable power. Wanted to get a bran new one and use this for backup at the lodge.
Nope.
It would of had to be destroyed and an afadavid signed with pictures showing a hole punched in the block at the serial number along with the rest of the documentation or u can not get the same replacement.
Any outright new purchase of a gen this big will be one with a catalytic converter and meeting current emissions standards.
This one is getting rebuilt at the original manufacturer. Engine power source Rock Hill South Carolina the warranty it just the same as a brand new one it's getting a brand new head but this engine block will be rebuilt with new parts.
I'm going back to Sundown for the bay insulation I've used them on all the gens I pull since I first did one on my XL.
That'll probably be 3 weeks turnaround time but when I do get it back and I start reviewing a day I'll throw a few more pictures up that sound down stuff is the best stuff out there everybody likes it. The old stuff that's in there is just crumbling away lot of buses out there just like it too.