We will see what if anything I get to this week ... but this is my current should do list ... not the full list of course!!


Finish setting up the new Bluefire monitor so I can watch the transmission temp. This summer, we had several high sump temperature codes. Three different shops reviewed and found nothing. The analog temperature gauge in the dash reads normally. However the sender is in the retarder circuit and is not driven from the wiring harness mounted thermister that sends the error codes. I have confirmed that the bluefire will read this sensor and will hopefully give me more information. BTW, my scangauge D will not read the trans temp even after working with the scangauge tech department.

Check Parliament OTR condenser fans to see if both are running
Re-glue the electronics cabinet latch
Replace the Aquahot webasto controller and see if it cures the shut down issue.
Trouble shoot the Aquahot bedroom water pump and backflow preventer. I am not getting water to the coil.
Figure out why the passenger wiper arm lock nut is loose
Re-rivet the small front awning mounting plate. No clue how this broke loose

Re-charge the Spot Free rinse repair
Re-charge the water softener
Add air to the tires now that it is cold
Polish drivers side wheels