Tire Pressure Monitor Recommendations

[georgew]

What do you use for tire Pressure Monitor with a toad

[Fratto]

Seems like most people talking about this on POG are using TST or Pressure Pro.

[Dockholiday]

I would say to NOT buy a TireMinder setup. I have (had) one on toad and bus - recently took them off because of dissatisfaction with performance. NFG. I’m open to suggestions as well!

[VASpartan]

Following as well and interested in the two that Mark suggested.

[georgiapeachinc]

Mike,
Take a look at this. https://rvibrake.com/products/rvibra...f642703a0d0993
they have a complete brake system and air pressure monitor for all axles on the toad and your bus. Getting it set up takes a little installation. I had the whole system installed in about two hours. The key is placing the hub within good distance of the toad and the unit at the dash board. It works very good. Only draw back I had was if you let the tablet go dead it takes quite a while to get it charged up and running. I found that if I plug the tablet in about an hour before I am ready to go it works flawlessly. The directions are easily understood. Check it out. It's another option.

[Fratto]

Good Morning Chris!
I did not know that RVI was doing this. Where did you end up putting the hub so that it was able to see the toad and the front tires? Also what did you do to mount the sensor on the inner dual?

[MIsheeTX]

I would say to NOT buy a TireMinder setup. I have (had) one on toad and bus - recently took them off because of dissatisfaction with performance. NFG. I’m open to suggestions as well!

I have had less than great performance from mine on our Marathon H3. Would replace it if feasible.

Mike