johnbrowder
06-18-2011, 12:59 PM
I am installing a Totalvision rearview camera system. This requires a new 14 conductor wire from the dash to rear cap. I initially tried going thru the basement tunes, but they are packed. I spoke to Troy and he said they would use the right side interior wire chase and route the wires up and over the entry door and to the back. Simple enough, right?
Well I cannot figure how to expose the wire chase between the entry door and first side window. On my previous Royale you removed 4 screws and all the interior column/trim came off. I can sort of get to the top of the chase by the forward cruiseaire, and sort of the bottom thru some switch openings. But it it too tight for a large new wire. I think I need to expose it and open it up a bit.
Do any of you liberty owners know how to disassemble this trim? Any other plan if attack?
Thanks in advance!
Well I cannot figure how to expose the wire chase between the entry door and first side window. On my previous Royale you removed 4 screws and all the interior column/trim came off. I can sort of get to the top of the chase by the forward cruiseaire, and sort of the bottom thru some switch openings. But it it too tight for a large new wire. I think I need to expose it and open it up a bit.
Do any of you liberty owners know how to disassemble this trim? Any other plan if attack?
Thanks in advance!