PDA

View Full Version : Posi-Trac Rear End in Bus ?



Gary & Peggy Stevens
03-27-2009, 12:44 AM
Ok, this is something I never heard before, till today, so I thought I would put it out there for validity?

Is it true that only ( One ) set ( side ) of the dual drive tires receives power from the differential? The other opposite set just turns freely? I was sure that in a rig this size they would have a posi-trac differential set up, so you got power from both sets of drive tires?

Is this a stupid question? :o Did everybody else no the answer to this? :o

Gary S.

Kenneth Brewer
03-27-2009, 02:50 AM
No, it is not true, both sides are driven unless an axle broke or something was mis-assembled. Posi-traction is not something commonly available or normally required because there is generally more than enough weight and traction.

The term posi-traction is or was a trademark and copyrighted name; there are other terms, such as limited slip, for one. In these manifestations, there are clutches incorporated that partially disengage or 'slip' in a 'limited' way when one side tries (has to) to turn at a different rate than the other (note the term 'differential'), as happens when negotiating a turn. However, that said, there are axles that will 'lock' on demand - both sides hard linked to each other. There a many designs and applications.

Newells had/may still have this feature, and of course other vehicles such as emergency vehicles such as certain fire trucks and off road vehicles. As I recall, this was done (Newell) with solenoids (electrically). There are a number of heavy drive axle manufacturers. Eaton, Dana, ZF, and so on. Design may be pneumatic or hydraulic, or mechanical (manual). When this feature is available - and engaged, it is only for poor traction situations -gravel, mud, snow. It may not be used on dry pavement because when one side wants to turn at the same revolutions as the other and can't unless there is forced tire slippage. Steering is/becomes very difficult in this circumstance.

This subject can be easily taken into technical sophistication which I don't think is necessary here, but no. Perhaps we should have a seminar on this at the OKC rally. Or you can ask an avid off-roader/4 wheeler.

Jon Wehrenberg
03-27-2009, 08:43 AM
While both sets of drive wheels will be driven on the highway, the purpose of a differential is to allow the wheels on each side to travel at different speeds. When turning in a tight circle for example the wheels to the inside of the turn cover a lesser distance than those on the outside of the turn so in that case the wheels stop turning in sync otherwise one set would be skidding.

When on slippery surfaces our differentials will allow the tires with the least traction to spin. A locked differential or a differential that delivers power to the wheels with traction prevents this. As Ken explains there are all sorts of systems to limit wheel slippage and the cars of today with full time all wheel drive employ many variations of traction control.

Unless you plan on going off-road, or driving a lot in the great frozen north our buses are set up just fine. We drove for many years in snow and the bus did OK.

merle&louise
03-27-2009, 10:10 AM
Ken & Gary,

All 3 of my Newells had a button on the dash labled "diff lock". When it is engaged (on) the coach drive axles pull together with no slip. I have used this feature twice when I was stuck in mud. The first time I was able to "walk out" of the muddy ground with the diff lock on and both wheels pulling. It is imperative to remember to turn "off" the diff lock after the coach is freed from the mud. The system worked great!

I became stuck a second time (read dumbass) and the use of the diff lock could not get me out of the mud this time. I had to call a wrecker and with his help I was able to get out. My point is the diff lock is a good thing to have, but it has limitations.

I will never get in that situation again. If I am going to park on grass, first I walk out and inspect the ground. If it is not hard sandy earth, I stay on the concrete or asphalt.

Joe Cannarozzi
03-27-2009, 11:13 AM
Does a newel have 2 rear-end gears like wanderlodge or 1 and a tag like Prevo.

Kenneth Brewer
03-27-2009, 11:34 AM
Does a newel have 2 rear-end gears like wanderlodge or 1 and a tag like Prevo.

Joe,

If you mean two rear diffs (two rear axles), like many trucks, I am not aware any bus or MH that had/has that, foreign or domestic, particularly Birds. Birds did not, they had a drive and tag like Prevosts (for BB pushers, some of the earlier 90s had a single rear axle). The tag wheel looks exactly like the drive axle, except it is/was just a single, just like the Prevo; but the wheel was directly in line with the outside dual in front of it. And yes, wear was more of a problem because of it, so Birds had the lifting tag axle as well.

Interestingly, for a domestic bus, the Eagle had the tag in front of the drive axle. I do not know why, particularly, but this became problematic when going forward over an obstacle in slippery conditions, such as a curb in snow or ice.

If you mean a (one) 2 speed rear axle, again I am not aware of any BB that had that either, unless it was an optional school bus feature for rural use, or one of their city/highway commercial buses. On those I cannot say.

Gary & Peggy Stevens
03-27-2009, 12:09 PM
Thanks guys for clearing this up for me. I am not sure why the guy (Prevo Owner) that I met yesterday thought there was only one side of drive wheels, but he thought that. His bus was a 97 or so Marathon.

I just wanted to get the answer from those that know for sure. :)

Thanks again.

Gary S.

Kenneth Brewer
03-27-2009, 12:32 PM
Thanks guys for clearing this up for me. I am not sure why the guy (Prevo Owner) that I met yesterday thought there was only one side of drive wheels, but he thought that. His bus was a 97 or so Marathon.

I just wanted to get the answer from those that know for sure. :)

Thanks again.

Gary S.
Many people have this misconception. I think it has to do with seeing one wheel spin in slippery conditions (especially on vehicles that have what is called an 'open' differential, although it happens under certain conditions with "posi's") and incorrectly concluding that only one wheel is ever driven. Wrong.

This would be better explained with a model of a differential. If there is sufficient interest, perhaps I may be able to obtain one and I or someone else can explain/demonstrate the principle of the differential at the OKC rally. If there is sufficient interest, time, and permission to do it.

Jon Wehrenberg
03-27-2009, 01:16 PM
Ken,

It would be a good round table type discussion for anyone interested. I know some owners have taken their bus in places they should not thinking they can use the weight of the bus to get traction only to find out that when the surface gets slippery, as in mud or snow they are stuck. I do not know of any coaches with any kind of traction control differentials. But with Prevost in Canada it is likely there are some coaches out there with limited slip differentials.

I won't attend the session however, not because I don't like you, but after far too many years dealing with average annual snowfalls of 240 inches I will not be driving on snow covered roads ever again. At this point I don't care if my bus has all wheel drive or two wheel drive.

Kenneth Brewer
03-27-2009, 01:51 PM
Jon,

Actually, I was thinking you would do the session; I don't like me. I think I could get the working model if this demo is wanted.

Kenneth Brewer
03-27-2009, 02:12 PM
Jon makes the important point. While this may still be legitimate for the discussion's sake, for mud or sand, this feature only occasionally works, for other reasons. The weight of these coaches more likely will help getting more stuck as holes are dug by the drive axle wheels. Yes, very handy that one or two times. But Newells get stuck too, as drivers may think they can just hold the throttle on and wait. Then the shovels come out, if it's possible to dig under the coach bottom.

Perhaps more to the point, it's unlikely, if not out of the question, to convert. It means replacement of the drive axle with one that has a locking differential, plus the ancillary equipment that goes with it. Huge undertaking probably more expensive than an engine rebuild or replacement/exchange, if anyone contemplated it.

Anyway, that's pretty much the story.

Jon Wehrenberg
03-27-2009, 02:25 PM
Jon,

Actually, I was thinking you would do the session; I don't like me. I think I could get the working model if this demo is wanted.


Ken, the hell with the model. Let's get Gary Stevens bus and see if we can get it stuck at the sheep farm. After all, actions speak louder than words.

I know there will be a sheep farm out at the OKC rally.

merle&louise
03-27-2009, 06:29 PM
Yeah, let's get Gary's coach stuck in the mud!:eek:

How about it Gary, will you volunteer your coach for a mud test?

lewpopp
03-27-2009, 11:33 PM
Know Jon, you can't run away from noing the noledge of the rearend.

I thought you really nue this stuff and you don't no crap.

Anyone getting my drift. Anyone go to high school in this bunch? I don't no if you did.

garyde
03-27-2009, 11:54 PM
Here's a related link regarding traction: http://www.prevostcar.com/cgi-bin/pages.cgi?page=sh_esp_passenger

tdelorme
03-28-2009, 08:48 AM
Lew, in Texas, English is taught as a second language. I NO this fur a fact.

Jon Wehrenberg
03-28-2009, 11:28 AM
Lou,

Doesn't Kathi have something for you to do? You have way too much time on your hands.

The Prevost stability control system reacts by brake application which should transfer power to the wheel with traction while trying to get Gary's coach out of the mud at the sheep farm. However I drove a Lexus with a similar system on snow covered surfaces and I can tell you it was scary because when you want to go, such as pulling out onto a highway the damn thing reduced power to the drive wheels via braking and engine control and left me half on the highway and half on the driveway. There is a time when controlled wheel spin is necessary.

Joe Cannarozzi
03-28-2009, 11:32 AM
Jim Scoggins owned a Bluebird with tandum rear axles.

Kenneth Brewer
03-28-2009, 12:43 PM
Jim Scoggins owned a Bluebird with tandum rear axles.

I would like to be sure I understand what you mean by tandem axles. If you mean both axles driven, I would have to say that Bluebird probably didn't build it. That would require a second driveshaft between the first and second differential. It would likely mean a different spacing between both rear axles, which means frame changes. It would mean a modified suspension layout because the torque reaction of the second differential would have to be taken out somewhere with a link to the frame. Different rear axles would be required than what was supplied on other Bluebirds.

If you mean duals on the tag axle, I have heard of this, but not seen it personally. And I wonder why it was done, because the tag axle rating would not change with this modification alone.

If there are pictures I would love to see them.

Joe Cannarozzi
03-28-2009, 12:51 PM
There is a thread in the archives somewhere where he talked about blowing the spider gears in the nosecone in the front rear and had to leave the bus out of town and finish the trip home in the toad.

PLSNTVLE2
03-28-2009, 01:12 PM
As mentioned in an earlier post, my bus also has the "locking differential" feature. I can electronically actuate it from the dash. I believe this would be used if you are on a soft, sandy or muddy surface.

I have not had my bus buried in the mud yet and I will continue to avoid it, but I am from time to time in need of extra traction on ice.

I will usually lift the tag axle to allow all of the weight transfer to the drives. Once I get moving I drop the tag back down and your on your way.

It Works !

Gary & Peggy Stevens
03-30-2009, 01:23 PM
Jon, while it was very nice of you to offer "MY BUS" as the guinea pig testing vehicle in the sheep farm mud drive, traction control test, but you will have to talk to my Boss. :eek:

My guess is she will say NO! :p

But you know I would love to help in any other way, since I am of very little help now in anything bus related, me being such a neubie to all of this. But please let me know if I can be of help in any other way. :)

Margaritas anybody !

michaeldterry
03-31-2009, 04:29 PM
Margaritas anybody !

Gary - every time I see "Sugar Land, TX" in the sig of one of your posts, it makes me think of my former home in Greatwood, also in Sugar Land, TX, where I lived from March 1990 to July 1999. We loved it there! My son was a member of the Ft. Bend Boys Choir for several years and toured Europe twice with them!

When we lived in Texas, I had not yet discovered Prevosts, though. My coach of choice back then was my Silver Eagle 10 entertainer conversion that I bought from Barbara Mandrell when she retired from touring.

Gary & Peggy Stevens
03-31-2009, 11:46 PM
Michael we do live in Greatwood, in Sugar Land. I sent you a PM.

Gary S.