PDA

View Full Version : Inverter Settings ...



Ray Davis
11-03-2008, 04:26 PM
Does anyone know the correct settings for a Trace inverter for the battery charging of AGM house batteries.

IN particular I was wondering about those paramters listed on page to (setup -> battery charging), which include

1. Bulk volts DC
2. Absorption time (h:m)
3. Float volts DC
4. Equalize volts DC
5. Equalize time (h:m)
6. Max charge amps DC

IN particular I was worried about the next, because mine is set for "lead acid". I have AGM batteries, however AGM does not appear to be a selectable entry?

7. Temp Comp (Lead Acid, NiCad) (AGM doesn't seem to be a selection)


Any other paramters to check on this? Bus is 250 miles away, but I'll probably be going out this weekend to check.

Ray

Jon Wehrenberg
11-03-2008, 04:35 PM
Ray,

Try this site. I refer to it frequently, and they also will respond to questions. What I also do is go to the battery manufacturer's web site.

http://www.windsun.com/Batteries/Battery_FAQ.htm#Using%20a%20deep%20cycle%20battery %20as%20a%20starting%20battery

I would also suggest you go to the inverter manufacturer's owner's manual. My Heart Interface manual is excellent and I am sure all inverter manufacturer's provide advice on inverter settings.