Trace error message

[Dthomas9572]

Hello,

I have Trace invertors 4024 MC2. One has a "red" error blinking that I can't seem to get to turn off. It is working as it should...Anyone with thoughts on the issue? Thanks

[Hoffman]

David,
According to my Trace documentation, here's what it says about that Error light.

Indicates that an operating error has occurred (refer to the ERROR CAUSES (5) menu heading for a listof possible causes). To reset the inverter, press the red ON/OFF MENU button and then select OFF andthen ON with the SET POINTS buttons or by pressing the red button several times.




Did you dig into the Error Causes menu (9) to see what it reports? I would do that before going thru the reset sequence.